Firmware:

- Improved "s1 - s2 only" detection on entry through s1 / s2. s1 / s2 now only reverse when exiting the loop, entry is always on short-detection.
- Improved short detection in case loco wheels bridge both the isolation gaps at the same time.

App:

- none

Firmware:

- LocoNet implementation overhauled to: * avoid LocoNet getting stuck because of collisions.

App:

- none

Firmware:

- power applied to the loop-rails after "cold-start"
- FB_GND & FB_CS now always indicate occupation, even if S1-T-S2 feedbacks are set to 0
- short-circuit recovery improved.Pressing the POL buttun now also clears short-circuit status.

App:

- None