Firmware:

- Märklin Motorola Track-protocol Implemented. Protocol DCC <-> MOT recognition is fully automatic and both kan be used simultaneously.
- For the Fleischmann protocol now Step-left und Step-right are available.
Thos commands are available under addresses:
<Base-address> + <number of exits> + 1 for Step-left,
<Base-address> + <number of exits> + 2 for Step-left,
"Red" turns with the Bridge-house to the next exit. "Green" with the other end.

App:

- none

Firmware:

- minor LocoNet fix

App:

- none

Firmware:

- LocoNet implementation overhauled to:
* avoid LocoNet getting stuck because of collisions.
- Märklin Z turntable added.
- remember last selected exit (for TrainController)
- Left/right single step for Märklin protocol added.
- Left/right manual turning of the bridge, without selecting an exit.
- Emergency Stop (stop turning) implemented.
- Power/Signal monitoring added.
- Timing for latch-coil and motor made adjustable.
- Stepper-Motor control added.
- "Watchdog" added ==> Bridge stops when a selected position is not being reachd within a certain amount of time.

App:

- Changes to reflect/enable the new FW feature

Firmware:

- Support for Arnold N turntable added
- Added "active" / "inactive" exits to support TrainController(r)
- Last turned position is now saved, so no spuriuos turn will occur after "cold start"

App:

- Support for Arnold N turntable added
- Added "active" / "inactive" exits to support TrainController(r)

Firmware:

- Commanding via DCC enabled
- "C-Type" turntables now switch the correct end-piece rail on the bridge
- Bridge-is-turning Feedback now can be inversed into "Bridge-is-stopped"

App:

- Bridge-is-turning Feedback now can be inverted into "Bridge-is-stopped"

Firmware:

- initial version

App:

- initial version